Code compliance requires new soffits to have built-in venting, to the tune of 25% of the area. The original soffits had no venting. Essentially, the attic pulled in its air through any cracks and holes that would have been in the attic, and then through the attic hatch, which was not insulated. I have no idea whether that was sufficient or not, but the whirlybird on the roof was always spinning, so I know there was air movement.
New soffits with venting make matching to my original soffits quite impossible. The Builder has done the best he can, I think. He’s installed a wood beadboard product that looks like tongue and groove, with a strip of venting.
The Builder says the venting strips have to go along the north and south of the house, and not along the west. The west would have been preferable, as then they would have been out of sight entirely. However, he says I did not have a choice.
I’ll be painting it in the summer and hopefully it will blend in a little better. As it is, it looks obvious and unsuitable and doesn’t match up at all, so I may have to replace the original soffit to match the new. Will assess in the summer.
I notice that the eavestrough corner looks pretty rough ….